high vacuum fume extractor supplier Motor and fan are arranged in the upper shell, dust filter bag, hopper and dust hopper are arranged in the lower shell, dust filter is installed between the upper shell and the lower shell, the dust filter bag is connected with the dust filter frame, elastic gasket is provided between the frame and the dust filter frame. The vibration motor is connected with the dust filter frame through the vibration mechanism, the air intake is arranged on one side of the lower shell, and the air outlet is arranged above the upper shell. The motor and the vibration motor are respectively connected with the electric control box. The dust collector has the characteristics of compact structure, easy operation, low noise, good dust removal effect, and can be directly applied to small places and laboratories.

The selection of high vacuum fume extractor supplier is particularly simple. Below, I will tell you the specific method:

First, with the accumulation of dust on the surface of the filter material, the speed and resistance of the dust collector are correspondingly increased, when the pressure difference on both sides of the filter material is very large, some of the fine dust particles that have been attached to the filter material will be squeezed in the past, so that the speed of the dust collector will decrease.

Second, the resistance of the dust collector is too high, which will significantly reduce the air volume of the dust removal system. Therefore, after the resistance of the dust collector reaches the value, the ash should be cleaned in time. The primary layer should not be destroyed when cleaning, so as not to reduce the speed.

Third, mainly according to the size of the dust removal amount needed by the user, and the condition of the site to decide, this dust collector equipment has a simple structure, convenient operation and maintenance.

Fourth, after the use of filter material for a period of time, due to screening, collision, retention, diffusion, static electricity and other effects, the surface of the filter bag accumulated a layer of dust, this layer of dust is called the first layer, in the process of movement after this, the first layer became the main filter layer of the filter material, relying on the role of the first layer, the filter material with large mesh can also obtain a better filtration rate.

The dust-containing gas enters the dust collector from the lower part of the dust collector and is filtered through the dust bag, and the clean air is discharged by the induced draft fan. After the dust collector works for a period of time, the dust on the filter bag gradually increases, causing the Yin force of the filter bag to rise, and the dust collector needs to be cleaned, and the dust collector will work normally after the cleaning is completed. high vacuum fume extractor supplier unit has six specifications, divided into three, a type of door, a drawer, a type of neither a door nor a drawer; The lower part of the addition is directly connected to the dust removal equipment such as the top of the warehouse, the silo, and the transportation point of the belt transportation, etc., and the dust is directly recovered. The high vacuum fume extractor supplier shall install it near the mechanical equipment that produces dust, and shall be provided by the user according to the size of the upper inlet of the dust collector. Configure the metal or plastic pipe and dust cover (can also be designed by the manufacturer), the dust collector should check the access door before the work, the flange connection is sealed, so as to avoid air leakage, reduce the dust removal effect. Dust collector, voltage, from the dust collector external wire street power supply can start to use, the initial operation, should pay attention to the fan rotation direction (such as reverse, need to replace the power wiring. The cover of the dust collector control cabinet can not be opened at will in the studio, if it is necessary to adjust the cleaning time, or repair the circuit, it should be stopped or cut off the power supply. According to the nature of dust and the size of dust concentration, adjust the timing of cleaning. Vacuum cover is a key part of the dust collector in the state, the use of units should be connected according to the size of the workpiece and the nature of the dust, close, seal, and design the principle of dust cover, the production of ideal dust cover.

high vacuum fume extractor supplier https://www.kaisenfilter.com/High-Vacuum-Fume-Extractor