Installing an air conditioner is not as difficult as you think. If you follow the proper steps, it really is not that hard to do. One thing you want to make sure before you start installing is that the cooling unit is connected to the outside faucet and drain correctly. This is important to avoid leaks. With the pieces cut and ready, you can start to install.

Before you start to install your air conditioning unit, you will want to make sure that you have the proper screws in place. Using a handy flathead screwdriver, carefully pry out the old air conditioning unit from the inside window frame. Using a saw, cut along the 2 x 4's evenly into the following sizes: (2) Window Opening of the exterior air conditioning unit.

(3) The interior side of the exterior frame. (4) Installation of your new ac unit is fairly simple if you have a few basic tools. However, if you are like many people and are not familiar with electrical work, you will need the use of a good electrician to install your new air conditioner. Make sure that the electrician you hire has a license and is insured. Also ask him or her for some advice if you have any questions or concerns.

The next step is to secure the new frame to the wall. If your unit comes with a manual, follow the step by step procedures exactly as it is written. If you are installing the air conditioner on your own, you can either use screws of nails. You should make sure that the unit is installed properly and securely. Installing the unit over an existing frame can be tricky so it is best to know how the frame goes before hand.

The third step in the installation process is placing the air conditioner properly on the frame. Depending on the type of unit, you may want to place the AC unit inside the door or inside the window sill. It is best to drill pilot holes before mounting the unit inside the structure. You can either use the standard screw method or special plastic tabs that make it easier to screw the support brackets to the frame. No matter what method you choose, make sure the screws are screwed in tightly and down deep enough that you cannot accidentally pull them out.

After you have mounted the air conditioner to the window frame, the final step is installing the sash. Mounting the sash, you should measure the opening between the sash and the wall and divide this measurement into two pieces - one for the outside sash and one for the inside sash. Once you have these measurements, take those measurements and add them to the width and height measurements of your window frame. Once you have this information, you can purchase the right size unit for your home.

Once you have the right size window frame, you will need to start installing the unit. The first thing you will need to do is get the two screws for the cord off the wall. Since you will not be using the cord, it is not necessary to hang the air conditioner from these two screws. Once the frame is installed, you will need to screw the two screws into the wood window frame exactly where they are located.

The last step in the process is simply to hang the AC unit from the two screws that are holding the window frame in place. Once ติดตั้งแอร์ is done, you will need to install the outlet and turn the air conditioner on. A good way to find your correct setting is to look at the manual that came with your system. This will give you the accurate setting that is appropriate for your room. If you don't know your settings, simply adjust them until you get the right temperature.